正确使用
自动搅拌一体机有利于施工的顺利进行,并且可以提高工程工作效率,如果没有正确使用会损害设备的机械部件,减少它的使用寿命。使用时的重中之中是要严格按照使用说明进行操作,一般在夏季如果自动搅拌一体机温度过高应该立刻停下来,等温度降下来后再继续使用。
The correct use of the automatic mixing machine is conducive to the smooth construction, and can improve the work efficiency of the project. If not properly used, it will damage the mechanical parts of the equipment and reduce its service life. The most important thing in use is to operate in strict accordance with the instructions. Generally in summer, if the temperature of the automatic mixing machine is too high, it should stop immediately and continue to use after the temperature drops down.
1、操作自动搅拌一体机注意液压系统压力应符合使用说明书中的规定,不得随意调整。液压油的油质和油量应符合原定要求。
1. When operating the automatic mixing machine, pay attention that the pressure of the hydraulic system should comply with the provisions in the operation manual, and should not be adjusted at will. The quality and quantity of hydraulic oil should meet the original requirements.
2、操作自动搅拌一体机注意装料前,应先排净拌筒内残存的积水和杂物。在运输过程中要不停的转动,以防混凝土离析。混凝土搅拌运输车到达工地和卸料之前,应先使拌筒全速以14—18转/分转动1—2分钟,然后再进行反转卸料。反转之前,应使搅拌筒停稳,然后再开启反转。
2. Before operating the automatic mixing machine, pay attention to drain the residual water and sundries in the mixing drum before loading. In the process of transportation, keep rotating to prevent concrete segregation. Before the concrete mixer truck arrives at the construction site and unloads, the mixing drum shall be rotated at full speed at 14-18 rpm for 1-2 minutes, and then reverse unloading shall be carried out. Before reversing, the mixing drum should be stopped stably, and then turn on the reversal.
3、环境温度高于+25摄氏度,从装料、运输、到卸料延续时间不得超过60分钟,环境温度低于+25摄氏度,上述时间不得超过90分钟。
3. If the ambient temperature is higher than + 25 ℃, the duration from loading, transportation to unloading shall not exceed 60 minutes; if the ambient temperature is lower than + 25 ℃, the above time shall not exceed 90 minutes.
4、冬期施工时,应切实做到:开机前检查是否结冰;下班时认真排除拌筒内及供水系统内残存积水,关闭水泵开关,将控制手柄置于“停止”位置。
4. During winter construction, it is necessary to check whether there is icing before starting the machine; when off duty, carefully remove the residual water in the mixing drum and water supply system, turn off the water pump switch, and put the control handle at the "stop" position.
5、在施工现场卸料完毕后,应立即用该设备随带的软管冲洗进料斗、出料斗、卸料溜槽等处,粘附在车身各处的污泥及混凝土。在返回搅拌站的途中,应向搅拌筒内注150---200L水以清洗筒壁及叶片粘结的混凝土残渣。
5. After unloading at the construction site, the inlet hopper, discharge hopper and discharge chute should be flushed with the hose attached to the equipment to remove the sludge and concrete adhering to the vehicle body. On the way back to the mixing station, 150-200l water should be injected into the mixing drum to clean the concrete residue bonded by the cylinder wall and blades.
6、每天工作结束后,司机应负责向自动上料混凝土搅拌车搅拌筒内注入清水并高速(14—18转/分)旋转5—10分钟,然后将水排去,以保证筒内清洁。用高压水清洗搅拌筒各个部分时,应注意避开仪表及操纵杆等部位。压力水喷嘴与车身油漆表面间的距离不得小于40厘米。
6. At the end of each day's work, the driver should be responsible for injecting fresh water into the mixing drum of the automatic loading concrete mixer, rotate it at high speed (14-18 RPM) for 5-10 minutes, and then drain the water to ensure the cleanness of the drum. When cleaning each part of the mixing drum with high pressure water, pay attention to avoid the instrument and control rod. The distance between the pressure water nozzle and the paint surface of the vehicle body shall not be less than 40 cm.
今天的关于如何使用
自动搅拌一体机可以提高工作效率就分享到这里,若您需要了解自动搅拌一体机其他问题欢迎及时联系我们,或登录我们的网站进行查询,感谢您一直以来的关注和支持。
Today's about how to use the automatic mixer can improve work efficiency. If you need to know about other problems of the automatic mixer, please contact us in time, or log in to our official website for inquiry. Thank you for your attention and support.