搅拌一体机的轮胎多少时间更换？_公司新闻_新闻资讯_自动搅拌一体车_自动搅拌一体机

站内搜索

新闻资讯

公司新闻行业动态

热点

自动上料平口搅拌机多种方量可供选择

2022-12-23

混凝土自动上料搅拌车的功能有哪些？

2022-12-19

混凝土自动拌料车移动式可自行走户外施工

2022-12-16

自上料搅拌车企业这么多，买车的时候应该看哪方面？

2022-12-12

关于山汽

联系人：刘老师

电话：400-879-1999

公司：山东山汽工程机械（集团）有限公司

地址：山东省莱州市206国道与308省道交叉口东南50米

搅拌一体机的轮胎多少时间更换？

所属分类：公司新闻发布时间：2021-03-23 来源：http://www.shanqijituan.cn/ 浏览量：0

随着独立式搅拌机的成本不断增加，轮胎的价格也随之增加。

As the cost of stand-alone mixers increases, so does the price of tires.

1.轮胎胎面深度。

1. Tire tread depth.

胎面花纹厚度必须大于1.6毫米。如果在低摩擦的潮湿路面上行驶，请确保胎面花纹厚度是上述值的两倍。您可以向学习并购买量规以测量胎面花纹的厚度；然而，老驾驶员提出了一种流行的方法来粗略估计胎面花纹的厚度。经常用到。由于从边缘到顶部的距离为1-2 mm，因此将胎面凹槽向顶部插入。此时，可以看出整个胎面花纹的厚度不足。

The tread thickness must be greater than 1.6 mm. If driving on wet roads with low friction, make sure that the tread thickness is twice the above value. You can learn from experts and buy gauges to measure tread thickness; however, veteran drivers have come up with a popular method to roughly estimate tread thickness. It's often used. Since the distance from the edge to the top is 1-2 mm, insert the tread groove towards the top. At this time, it can be seen that the thickness of the whole tread pattern is insufficient.

2.花纹磨损指示线。

2. Indication line of pattern wear.

与过去的旧胎面花纹磨损指示器相比，新轮胎设计更加人性化。如果轮胎是很新的轮胎或磨损很少，则这些指标几乎可以忽略不计，但是当磨损达到一定程度时，这些隐藏在胎面花纹沟中的线条就会出现。胎面花纹磨损指示线是沿着胎面的长度垂直地嵌入胎面凹槽中的扁平橡胶条。检查轮胎，有时会发现一条或两条指示线导致胎面花纹厚度显着减小。在这种情况下，请在湿滑的路面上行驶时要小心。如果轮胎上几乎所有的指示线都清晰可见，则意味着需要尽快更换轮胎。

Compared with the old tread wear indicator, the new tire design is more humanized. If the tire is very new or has little wear, these indicators can be ignored. However, when the wear reaches a certain level, these hidden lines will appear in the tread groove. The tread pattern wear indicator line is a flat rubber strip vertically embedded in the tread groove along the length of the tread. When checking a tire, it is sometimes found that one or two indicator lines result in a significant reduction in tread thickness. In this case, be careful when driving on wet and slippery roads. If almost all the indicator lines on the tire are clearly visible, it means that the tire needs to be replaced as soon as possible.

3.轮胎胎侧裂纹。

3. Tire sidewall crack.

并非所有的轮胎问题都集中在胎面中，轮胎侧壁有一些问题。寻找轮胎侧壁上的可见裂纹或切口。这些小凹槽表明轮胎将来可能会漏气，更糟糕的是，轮胎可能会爆裂。我们要避免这些轮胎的故障。因此，如果轮胎胎侧裂纹看起来更严重，请将车辆开到修理厂并尽快更换轮胎。

Not all tire problems are concentrated in the tread, and there are some problems in the sidewall. Look for visible cracks or cuts in the tire sidewall. These small grooves indicate that the tire may leak in the future, and worse still, the tire may burst. We need to avoid these tire failures. Therefore, if the tyre sidewall crack looks more serious, please drive the vehicle to the repair shop and replace the tyre as soon as possible.

4.轮胎胀大和胀大。

4. Tire swell and swell.

在某些情况下，由于强度不足，轮胎的外表面可能会升起并在普通轮胎的表面上方起泡。轮胎面临类似情况。如果未及时将车辆送往修理厂且轮胎及时失效，则胎面强度不足的区域可能会突然高速爆裂。轮胎破裂甚会对驾驶员或乘客造成严重伤害。

In some cases, due to insufficient strength, the outer surface of the tire may rise and blister over the surface of a normal tire. Tires face a similar situation. If the vehicle is not sent to the repair shop in time and the tire fails in time, the area with insufficient tread strength may suddenly burst at high speed. Tire rupture can even cause serious injury to the driver or passengers.

特别是在路况恶劣的情况下，驾驶车辆时不可避免地会发生一定程度的抖动。通过一些驾驶经验，您可以感觉到抖动在合理范围内，并且可以感觉到抖动表明车辆出现故障。

Especially in the case of bad road conditions, a certain degree of shaking will inevitably occur when driving the vehicle. Through some driving experience, you can feel that the shaking is within a reasonable range, and you can feel that the shaking indicates that the vehicle is faulty.

上一页：如何检查自动搅拌一体车的防抱死系统？下一页：多功能搅拌车如何防止水箱粘在一起？

热门产品 / HOT PRODUCT