我们必须定期向多功能搅拌车的水箱中加水。以下是编辑添加水的步骤,希望对大家有所帮助。
We have to add water to the tank of the mixer regularly. Here are the steps to edit and add water, hoping to help you.
一,控制水箱的气压,并经常拧紧各种管接头
1、 Control the air pressure of the water tank, and often tighten all kinds of pipe joints
应将多少气压泵入油箱,该压力在出厂时已设置,无需调节。如果在特殊情况下需要调节,建议将压力控制在3.5Mpa左右,压力过高,不要爆炸。另外,在新车和日常使用中,必须随时拧紧管接头以防止其脱落。
How much air pressure should be pumped into the tank, which is set at the factory and does not need to be adjusted. If it needs to be adjusted under special circumstances, it is suggested that the pressure should be controlled at about 3.5Mpa. If the pressure is too high, do not explode. In addition, in the new car and daily use, the pipe joint must be tightened at any time to prevent it from falling off.
二,油轮加水步骤
2、 Water filling procedure of oil tanker
每个油轮的供水安排相似。在正常情况下,水箱要进行通风和注水,然后关闭阀门。在不使用的情况下,将控制杆放在中间。
The water supply arrangements for each tanker are similar. Under normal circumstances, the water tank should be ventilated and filled with water, and then the valve should be closed. When not in use, it is best to place the control lever in the middle.
三,冬天用完水箱中的剩余水
3、 Use up the remaining water in the tank in winter
在冬季,特别是在北方,用户每天收集汽车后应从水箱和管道中排出水,并将压缩空气吹入管道中,以吹走每根管道中的残留水,以防止管道因冻结而冻结和破裂。
In winter, especially in the north, users should discharge water from the water tank and pipes after collecting cars every day, and blow compressed air into the pipes to blow away the residual water in each pipe, so as to prevent the pipes from freezing and cracking due to freezing.
多功能搅拌车储水箱中加水步骤了解就是这样,你学会了吗?
This is how to add water to the storage tank of multi-function mixer. Have you learned it?