自动搅拌一体车散热器的使用方式
How to use radiator of automatic mixer
正确使用自动搅拌车有利于施工的顺利进行,并且可以提高工程工作效率,如果没有正确使用会损害设备的机械部件,减少它的使用寿命。使用时的重中之中是要严格按照使用说明进行操作,一般在夏季如果自动上料搅拌车温度过高应该立刻停下来,等温度降下来后再继续使用。今天就让小编为大家简单介绍一下自动搅拌一体车散热器的正确使用方式:
The correct use of the automatic mixer is conducive to the smooth construction, and can improve the efficiency of the project. If not correctly used, it will damage the mechanical parts of the equipment and reduce its service life. During use, the most important thing is to operate in strict accordance with the instructions. Generally, in summer, if the temperature of the automatic feeding mixer is too high, it should stop immediately, and continue to use after the temperature drops. Today, let Xiaobian briefly introduce the correct use of the radiator of the automatic mixer
1、备用的散热器有效环境应保持通风、干燥。
1. The effective environment of standby radiator shall be ventilated and dry.
2、建议使用软硬水需软化处理后使用,避免造成散热器内部堵塞及水垢的产生。
2. It is recommended to use hard and soft water after softening treatment to avoid internal blockage of radiator and generation of scale.
3、在冬季为防止结冰造成芯子破裂现象,如搅拌车长期停车或间接停车时,应将水箱盖和放水开关,将水全部放出。
3. In winter, in order to prevent core cracking caused by freezing, for example, when the mixer stops for a long time or indirectly, the water tank cover and drain switch shall be set to drain all water.
4、水位计应每3个月清洗一次或视实际情况,各部件拆下用温水加无腐蚀性洗涤剂清洗。
4. The water level gauge shall be cleaned once every 3 months or as the case may be, and all parts shall be removed and cleaned with warm water and non corrosive detergent.
5、散热器内完全放水再注水时,要先将发动机缸体的放水开关扭开,有水流出时,再关上,从而避免产生水泡。
5. When the radiator is fully drained and then filled with water, the drain switch of the engine block shall be turned on first, and then closed when there is water flowing out, so as to avoid water bubbles.
6、在日常使用中应随时检查水位,要停机降温后加水。加水时,将水箱盖慢慢打开,作业人员身体应尽量远离加水口,以防高压蒸汽油加水口喷出造成烫伤。
6. Check the water level at any time in daily use, and add water after shutdown and cooling. When adding water, slowly open the water tank cover, and keep the operator away from the water inlet as far as possible to prevent scalding caused by the injection of high-pressure steam gasoline water inlet.
7、散热器不应与任何酸、碱或其它腐蚀性性质接触。
7. The radiator shall not be in contact with any acid, alkali or other corrosive properties.
8、在使用防冻液,为了避免散热器的腐蚀,请务必使用正规厂家生产且符合标准的长效防锈防冻液。
8. When using antifreeze, in order to avoid radiator corrosion, please use the long-term antirust antifreeze produced by the regular manufacturer and in line with the national standard.
9、视实际情况用户应在1~3个月间对散热器进行完全清洗一次芯体。清洗时,用清水沿反进风向侧冲洗。
9. Depending on the actual situation, the user should completely clean the core of the radiator within 1-3 months. When cleaning, use clean water to wash along the side of the reverse wind direction.
10、在安装散热器过程中,请不要损坏散热带(片)和碰伤散热器,以保证散热能力和密封。
10. During the installation of radiator, please do not damage the heatsink (sheet) and the radiator to ensure the cooling capacity and sealing.
正确的操作方式,能够有效提高
自动搅拌一体车散热器的使用效果,同时也能够防止在使用过程中因操作不当而对设备造成的损耗。希望这些知识能够帮助大家对设备进行合理的操作以及使用。
The correct operation mode can effectively improve the use effect of the radiator of the automatic mixing integrated vehicle, and at the same time prevent the loss of equipment caused by improper operation in the use process. I hope this knowledge can help you to operate and use the equipment reasonably.