自动搅拌一体机的发动机的错误用法_ 行业动态_新闻资讯_自动搅拌一体车_自动搅拌一体机

站内搜索

新闻资讯

公司新闻行业动态

热点

自动上料平口搅拌机多种方量可供选择

2022-12-23

混凝土自动上料搅拌车的功能有哪些？

2022-12-19

混凝土自动拌料车移动式可自行走户外施工

2022-12-16

自上料搅拌车企业这么多，买车的时候应该看哪方面？

2022-12-12

关于山汽

联系人：刘老师

电话：400-879-1999

公司：山东山汽工程机械（集团）有限公司

地址：山东省莱州市206国道与308省道交叉口东南50米

自动搅拌一体机的发动机的错误用法

所属分类：行业动态发布时间：2021-01-18 来源：http://www.shanqijituan.cn/ 浏览量：0

自动搅拌一体机的发动机是重要组成部分。这对每个人都是错误的做法。

The engine of automatic mixer is an important part. This is wrong for everyone.

搅拌一体机却强度不可调节，因此发动机通常在高温条件下运行，这会导致磨损增加和燃油消耗增加。实际上，高温对发动机有害。自动加载混合器的使用示例应限制在室温下，以确保发动机的使用寿命。

However, the strength of the mixer is not adjustable, so the engine usually runs at high temperature, which will lead to increased wear and fuel consumption. In fact, high temperature is harmful to the engine. Examples of the use of automatic loading mixers should be limited to room temperature to ensure engine life.

橡皮筋很好。如果皮带太松，不仅会拉伸或损坏皮带，不仅会缩短皮带的使用寿命，而且由于压力过大，搅拌车的发电机轴和泵轴的自动加载也会弯曲或变形。并对皮带造成初步损坏。轴承。自动装载混合动力发动机中的风扇皮带松动必须符合技术要求，通常建议通常照例进行10-15 mm的安装偏差。

The rubber band is very good. If the belt is too loose, it will not only stretch or damage the belt, but also shorten the service life of the belt. Moreover, due to excessive pressure, the automatic loading of the generator shaft and pump shaft of the mixer will be bent or deformed. The belt was damaged initially. Bearing. The looseness of the fan belt in the automatic loading hybrid engine must meet the technical requirements, and it is generally recommended to carry out the installation deviation of 10-15 mm as usual.

许多驾驶员都知道汽车刚刚起步。如果发动机转速过低，则会由于打滑不良而损坏发动机。但是，很少有人知道，由于加热而使应用程序在短时间内闲置时，自动电荷混合器的油泵由于转速低而无法迅速对光滑表面上的润滑剂加压。

Many drivers know that cars are just starting. If the engine speed is too low, the engine will be damaged due to poor slip. However, few people know that when the application is idle for a short time due to heating, the oil pump of the automatic charge mixer can not quickly pressurize the lubricant on the smooth surface due to its low speed.

同时，由于高温燃料的雾化不足，燃烧后的燃料进入曲轴箱，洗去了气缸壁上的油膜，并加速了零件的磨损。因此，在高温条件下，自供电汽车的发动机启动几秒钟后，有必要改善怠速加热并改善发动机打滑状态。

At the same time, due to the insufficient atomization of high temperature fuel, the burned fuel enters the crankcase, washes the oil film on the cylinder wall, and accelerates the wear of parts. Therefore, it is necessary to improve the idling heating and the engine slip state of self powered vehicle after a few seconds of engine starting under high temperature conditions.

上一页：自动搅拌一体机的涂漆表面该如何进行维护？下一页：自动搅拌一体车适用哪些工程？

热门产品 / HOT PRODUCT