使用
自动搅拌车一体车时,有排水步骤,如何正确排水?让我们来看看。
When using the automatic mixer truck, there are drainage steps. How to drain water correctly? Let's see.
启动自动搅拌车一体车和液压系统,以便将泵获得的动量用于驱动液压马达。排水泵几乎自动启动,切换到清洁状态,并准备控制操作按钮。排出水箱中的水,打开水箱底部的排水球阀,然后等待水箱中的水排出。按下排水系统按钮,并观察泵出口的状况。当供水停止从泵出口流出时,操作完成,泵中的水完全排干。
Start the all-in-one truck and hydraulic system of the automatic mixer to use the momentum obtained by the pump to drive the hydraulic motor. The drainage pump starts almost automatically, switches to the clean state, and prepares to control the operation button. Drain the water in the tank, open the drain ball valve at the bottom of the tank, and then wait for the water in the tank to drain. Press the drain system button and observe the condition of the pump outlet. When the water supply stops flowing from the pump outlet, the operation is completed and the water in the pump is completely drained.
根据以上过程,自动搅拌车一体车的泵排干干净,冬天不怕泵开裂。请注意,每次使用泵时,都必须将其排干。否则,它将在一夜之间被完全损坏,将无法使用。另外,在自动搅拌车一体车的强制排水过程中,必须注意泵的出口。
According to the above process, the pump of the automatic mixer truck is drained completely, and the pump is not afraid of cracking in winter. Please note that the pump must be drained every time it is used. Otherwise, it will be completely damaged overnight and will be unusable. In addition, attention must be paid to the outlet of the pump during the forced drainage process of the automatic mixer truck.
如何保持自动搅拌车一体车的漆面
How to keep the paint surface of automatic mixer truck
1.如果不使用自动搅拌车一体车的涂漆表面,则金属涂层会产生非常细的裂纹,并会继续渗透涂层,直到其渗透到整个涂层为止。如果裂纹中包含蜡,则身体上会出现条纹。定期打蜡可以逐渐减少裂纹。
1. If the painting surface of the all-in-one truck of the automatic mixer is not used, the metal coating will produce very fine cracks and will continue to penetrate the coating until it penetrates the whole coating. If the cracks contain wax, streaks appear on the body. Regular waxing can gradually reduce cracks.
2.自动搅拌车一体车在暴露于阳光的紫外线下会蒸发并保护空气中的油,随着时间的流逝,涂料会过度分散。油漆表面的亮度和深度大大降低,油漆表面逐渐变白,形成氧化层,缩短了油漆寿命。如果自动搅拌车一体车的油漆表面被严重氧化,则可以通过研磨和抛光对其进行处理。
2. The all-in-one truck of automatic mixer will evaporate and protect the oil in the air when exposed to the ultraviolet rays of sunlight. As time goes by, the coating will be excessively dispersed. The brightness and depth of the paint surface are greatly reduced, and the paint surface gradually turns white, forming an oxide layer, which shortens the paint life. If the paint surface of the automatic mixer truck is seriously oxidized, it can be treated by grinding and polishing.
3.由于自动搅拌车一体车,表面发生磨损。可能是昆虫,鸟粪,树汁,柏油和沥青所致。一些小的蚀刻可以通过研磨和抛光。
3. The surface of the automatic mixer is abraded. It may be caused by insects, bird droppings, tree sap, tar and asphalt. Some small etching can be done by grinding and polishing.
除了上述方法之外,为了有效地防止油漆溅到车辆上,在驾驶时必须注意驾驶并避免碰撞和摩擦。否则会发生其他损坏。
In addition to the above methods, in order to effectively prevent paint splashing on the vehicle, it is necessary to pay attention to driving and avoid collision and friction. Otherwise, other damage may occur.
Drainage operation and maintenance of automatic mixer truck paint surface understanding is like this, have you learned it?